aflamo AV-WM92PRI-S Manual Del Usuario página 11

Flame color button: Makes the color
flame effect changing.
NOTE: color effect stays on until power
button is turned off. Color flame effect
FLAME
must be on for fireplace to turn on.
COLOR
NOTE: this fireplace is with memory
function for flame.
FLAME button: Makes flame
effect dimmer and brighter.
NOTE: Flame effect stays on until
power button is turned off. Flame effect
FLAME
must be on for heater to turn on.
BRIGHTNESS
LED Ember light button: Makes the
color on bottom effect gets changing.
NOTE: Ember color effect stays on until
power button is turned off.
NOTE: this fireplace is with memory
EMBER
function for LED ember lights.
LIGHTS
LED Ember light brightness button:
Makes the LED ember lights on bottom
effect gets changing.
NOTE: LED Ember light brightness effect
stays on until power button is turned off.
EMBER
BRIGHTNESS
To improve operation, aim the remote control at the front of the fireplace. DO NOT
NOTICE
press the buttons too quickly. Give the unit time to respond to each command.
Remote Control Battery Information

Remote control uses one CR2025 battery (Included)
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center.
1. Press once. Flame color effect gets
changing.
2. Press again until desired setting is
reached. In total 3 colors for flame.
1. Press once. Indicator light turns
on. Flame brightness effect gets
changing.
2. Press again. until desired setting
is reached.
1. Press once. LED ember light color effect
gets changing.
2. Press again until desired setting is
reached. In total 10 colors for EMBER.
3. Auto-cycle function: When pressing with
the 11
auto-cycling (NOTE: It will take 15
seconds to switch between colors.)
1. Press once. LED ember light brightness
effect gets changing.
2. Press again until desired setting is
reached. In total 5 levels.
www.aflamo.com
time, the LED ember light will do
th
11