Sauder Office Port 408365 Manual De Instrucciones página 15

Step 11
Carefully stand your unit upright.
å
Insert a PIVOT HINGE (15H) into a WASHER (9I) and into
å
the BOTTOM MOLDING (I).
Insert the PIVOT HINGE, which is fastened to the DOOR (F),
å
into the hole in the TOP MOLDING (J). You will need to tilt
your DOOR slightly.
Now, tip the DOOR in and fasten the free HINGE to the
å
DOOR. Use a BLACK 9/16" LARGE HEAD SCREW (1S).
Repeat this step for the other DOOR (F).
å
NOTE: To make adjustments to the DOOR, loosen the
å
SCREW in the HINGE, make needed adjustments, and
tighten the SCREW.
www.sauder.com/services
J
F
15H
9I
BLACK 9/16" LARGE HEAD SCREW
(2 used for the PIVOT HINGES)
I
1S
408365
Pro Tip: Lift with your
legs. And, you know,
your arms.
Page 15