Indesit IDL 750 Manual De Instrucciones página 6

1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent ( see below ).
4. Load the racks ( see Loading the racks ) and shut the
door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are ( see table of wash
cycles ), by turning the knob clockwise.
6. Select the wash options ( see below ).
7. Start the cycle by pressing the START/RESET button:
the machine will emit a confirmation beep. The
WASH CYCLE PHASE indicator lights display the
status of the cycle:
Pre-wash, Wash,
8. At the end of the cycle three short beeps will sound
and the DRYING indicator light will flash.
9. Switch off the appliance by pressing the ON/OFF
button, shut off the water tap and unplug the
appliance from the electricity socket.
10. Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that
it has only just begun: press and hold the START/RESET
button for 4 seconds. After one long beep and three
short beeps, the WASH CYCLE PHASE indicator light will
switch off: select the new cycle and switch the machine
back on by pressing the START/RESET button.
Press the ON/OFF button and open the door, taking care
to avoid the escaping steam, and place the crockery
inside the dishwasher. Press the ON/OFF button again:
the cycle starts from the point at which it was interrupted.
If the door is opened during the wash cycle, or if there is
a power cut, the cycle stops. It starts again from the point
at which it was interrupted once the door has been shut
or the electricity supply is restored.
A successful wash also depends on the correct amount
of detergent being used, as recommended by the
manufacturer. Exceeding the recommended amount
does not result in a more effective wash and pollutes the
environment.
Rinse, Drying.
Only use detergent which has been specifically
designed for dishwashers.
Washing detergent
Pre-wash detergent
1. Open cover C by pressing
D
A
button D.
B
2. Pour in the detergent after
consulting the Wash cycle table :
• for powder detergent use
compartments A and B
• for tablets, when the cycle
requires 1 tablet, place it in
compartment A and close the
C
cover; when it requires 2, place the
second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
It is possible to delay the start time of the cycle by 12, 9,
6 or 3 hours.
1. Press the DELAYED START button: every time the
button is pressed, a beep is emitted and the selected
delayed start indicator light illuminates.
2. Select the wash cycle and press the START/RESET
button: after the beep sounds, the timer begins
counting down.
3. Once this time has elapsed, the indicator light
switches off and the wash cycle begins.
To adjust the delay time and select a smaller period of
time, press the DELAYED START button. To cancel it,
press the button repeatedly until the wash cycle begins
and the WASH CYCLE PHASE indicator light
corresponding to the start of the cycle in progress
illuminates.
When using multi-use tablets , press the 3in1 button.
This option optimises the results of the wash. The overall
duration of the programme increases by approximately
10 minutes.
This option is not recommended for use with wash
cycles which do not specify the use of multi-use tablets
( see table of wash cycles ).
* Only available in selected models.