Redial; Receiving A Telephone Call; Receiving An Intercom Call - EnGenius EP800H Manual Del Usuario

during the speaking or broadcasting.
d. Release
key to end the
broadcasting.
3. Broadcasting an individual handset
a. Enter the Handset ID and then press and hold
key (left top corner of keys).
b. Hear a long "Du..." sound while the initiating
handset broadcast all handsets within
communication coverage.
c. Start to speak the message to be broadcasted once you hear the "Du
Du" sound; the speakerphone of destination handsets will be opened
up. if it received the voice.
Re: the initiating handset press and hold the
during the speaking or broadcasting
d. Release
key to end the broadcasting.

Redial

1. Press REDIAL (Left) soft key.
2. The LCD shows the last phone number dialed. To dial
this number, press key.
3.
Use or key to scroll through the last 10
phone numbers dialed. Select and press
dial the selected number.
[Note] Intercom numbers (Handset ID) are not stored in
the last 10 numbers dialed log.

Receiving a Telephone Call

1. When an incoming call arrives, the LCD will show the
caller ID message, and the ringer will ring or vibrate
unless the ringer has been turned off.
2. If the handset is on the charger cradle (ringer will be
key is needed
key to
~27~
temporarily switched to "Ring" if it has been set to
"Vibrate"), lift the handset and press
conversation.
Re: You can turn on the "Any Key Talk" from MENU-5-2
Notes:
1. You can press SILENT
the call. Unlike turning off the ringer (from the handset menu),
the SILENT key operation is valid only for the current call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows "Private" or
"Unknown", the caller's information may have been blocked by
the caller or the originating phone company.

Receiving an Intercom Call

1. When an intercom call arrives (called from other
handsets, ex. Handset 12), the ringer will ring or
vibrate unless the ringer has been turned off. Press
to answer the intercom call.
2. If the handset is on the charger cradle (ringer will be
temporarily switched to "Ring" if it has been set to
"Vibrate"), lift the handset and press
conversation.
3. If the handset is not on the cradle and MENU-6-2 "Any Key Talk" setting is
"On", press any key (except
Notes:
1. The LCD displays the caller's Handset ID.
2. You can press the SILENT
the call. Unlike turning off the ringer the
valid only for the current call.
key to start
(Left) soft key if you choose to ignore
key to start
and the SILENT soft key) to answer.
(Left) soft key if you choose to ignore
SILENT key operation is
~28~