Layher 1401101 Instrucciones De Montaje Y Uso página 45

Basic assembly
Tower models 1401125, 1401127, 1401129, 1401131,
1401145, 1401147, 1401149 and 1401151
1. Insert the castors 1 into the 2.00 m ladder frames
against falling out by fastening the wing screws on the spindle nuts.
2. Connect the two rolling tower side parts to the top rungs and to the
bottom rungs, using two rear guardrails
3. Fit two diagonal braces 19 and the access deck 23. Ensure here that
the two diagonal braces are installed parallel to one another in the
direction of the access hatch.
4. To keep to the maximum spacing from the first rung, fit an access
ledger 9 on the access side of the rolling tower.
5. Climb up to the next level and fit additional rear guardrails
second rung above the platform surface. (Any double guardrails
stock must be installed as side protection for the first level. The rear
guardrails previously installed as an advance side protection are removed
again after the double guardrails have been fitted.)
Further assembly is in accordance with "Assembly of intermediate
platforms" (see on the right side).
13 and secure them
15 in each case.
15 to the
16 in
Assembly of intermediate platforms
All tower models
The following assembly steps 1 to 5 are repeated several
times depending on the assembly height.
1. Fit the first 2.00 m ladder frame
2. Attach the Uni assembly hook
frame 13 for fitting the rear guardrails 15.
3. Swing the ladder frame with the rear guardrail upwards, fit it in place
and secure it with spring clips 14.
13 and secure it with spring clips 14.
25 and position the second ladder
13