Portable Mounting Using Clamps; Mounting The Saw; Adjusting The Four Position Switch Handle - Bosch 4410L Manual Del Usuario

Transporting, Placement & Mounting

Portable Mounting Using Clamps

If necessary, clamp the miter saw to a workbench or
table top by placing two (2) or more "C" clamps on
the clamping areas and secure.
NOTE: Be careful not to place clamps over the base
extension clamping levers.
Mounting with clamps will prevent access to some
wide miter angles.

Adjusting the Four Position Switch Handle

Handle
Lock
Clamp
Handle
Rotation
Release
Lever
a.
Setting Main Handle in
Desired Position
The switch handle can be positioned in any of four
different orientations, depending on the cutting
situation and user preference:
a. Vertical b. 45° Left c. Horizontal d. 45° Right
To reposition the main handle:
1. Release handle lock clamp.
2. Pull and hold handle rotation release lever
3. Rotate handle to desired location.
4. Let go over release lever to set handle into
place. Release lever will retract down only in
one of the four (4) positions
All manuals and user guides at all-guides.com
Mounting Applications
b.
c.
Figure: Setting Main Handle Position
20.
Clamping
Areas
Clamping Areas
Figure: Portable Mounting Using Clamps
Note: Power switch can not be actuated unless
release lever is retracted down. Do not attempt to
switch tool on between handle position, damage may
occur.
5. Lock the handle clamp.
Adjusting the Four-Position Handle
Lock Clamp Tension
1. Open handle lock clamp.
2. Using 1.5 mm Allen wrench, increase tension by
turning both setscrews 1/4 turn to the left, tighten
by turning to the right. Always adjust both
setscrews by the same amount.
3. Close handle lock clamp.
4. Check the tension.
d.