Installation
Portable
Mounting
Using Clamps
If using bolts or screws is not possible, clamp the
slide compound
miter saw to a workbench
or
table top using clamps.
Place a "C" clamp on each of the clamping areas
and secure (Figure 17).
Note: Use of clamps will limit use of extreme
miter angles.
Clamping Area
I
Clamping Area
Figure 17. Portable Mounting Using Clamps
Stability
Bar Adjustment
For added support of the table during cutting, the
stability bar should be adjusted before use.
1.
Loosen the knob for the stability bar.
2.
Slide the stability bar up or down until it con-
tacts the workbench.
Note:
If the workbench
surface
is not flat,
the
stability
bar may require readjustment
at different
miter angles.
3.
Tighten the knob.
b
18.