Brush Assembly / Disassembly; Squeegee Assembly; Squeegee Disassembly; Squeegee Adjustment - Comet CPS 55 ADVANCE BYT Manual Del Usuario

6.3.

BRUSH ASSEMBLY / DISASSEMBLY

• Never use the machine if the brush or the pad
driver with abrasive pad are not perfectly installed.
Assembly:
Place the brush on the floor; lift the brush plate using
the foot pedal (Photo 8 - E); place the brush under the
brush plate of the making sure that the mounting
flange of the brush is under the metal coupling of the
machine.
Lower the brush plate and verify the correct position-
ing of the brush.
Turn on the machine with the ignition key.
Select the rotation of the brush through the switch
(Photo 6 - A); start the rotation of the brush with the
control lever (Photo 2 - A): in this way the brush will
couple automatically.
To couple the pad driver follow the same procedure.
•
Do not allow the length of the rows of brushes to
become lower than 1 cm.
•
Do not allow the thickness of the abrasive disks to
become less than 1 cm.
Working with excessively worn brushes or excessively
thin abrasive disks may damage the machine and the
floor.
Regularly check the wear on these parts before start-
ing to work.
For disassembly or replacing:
Lift the brush plate with foot pedal (Photo 5 - E).
Make sure the ignition key on the control panel is set
to "0".
Holding the brush in the hands, turn it the direction of
the rotation and lower it to release the couplin flange
of the brush plate.
To pull off the pad driver, follow the same procedure.
6.4.

SQUEEGEE ASSEMBLY

Avvitare leggermente i pomelli ( Photo 16 - A ) sui
Lightly tighten the knobs (Photo 16 - A) on the fixing
bolts of the squeegee (Photo 18 - B); place the squee-
gee on the support by inserting the pins into the slots
located on the support of the squeegee (Photo 16 - B).
Fix the squeegee to the support tightening the two
knobs (Photo 17).
Firmly insert the suction hose from the machine in the
connection pipe on the squeegee body (Photo 17 - D).
6.5.

SQUEEGEE DISASSEMBLY

Disconnect the suction hose from the connection
pipe on the squeegee body (Photo 17 - D).
Loosen the two knobs (Photo 16 - A) and pull the
squeegee to free it from its seat.
6.6.

SQUEEGEE ADJUSTMENT

The knob screw placed on the squeegee support
(Photo 17 - B) adjust the squeegee inclination to the
ground. The two red knobs on the sides (Photo 17 - A),
connected to the rear wheels of the squeegee, are to
adjust the pressure of the squeegee on the ground.
When the squeegee is perfectly adjusted, the rear
squeegee blade, sliding as it moves, bends in all
points forming an angle of 45° with the floor.
During the machine work it is possible to operate on
the knobs (Photo 17 - B) (Photo 17 - A) to adjust the
angle and pressure of the squeegee so that the drying
is uniform along the entire length of the squeegee.
Damp patches mean that drying is insufficient; rotate
the adjusting wheels to optimize drying.
Photo 16
A) Squeegee fixing knob
B) Slot for the attaching of the squeegee
D
Photo 17
A) Knob to adjust the squeegee pressure on the floor
B) Knob to adjust the squeegee inclination to the floor
C) Squeegee wheel
D) Suction hose
35
B
B
A
A
B
A
C