Makita DMP181 Manual De Instrucciones página 8

Lighting up the front lamp
When you turn on the tool by pressing the main power
switch, the lamp lights up. When you turn off the tool by
pressing the main power switch, the lamp goes out.
2
1
► 1. Lamp 2. Main power switch
Do not look in the light or see the
CAUTION:
source of light directly.
When the tool is overheated, the lamp
NOTICE:
blinks. Turn the tool off and let the tool cool down
fully before operating the tool again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Storing adapter
The adapters can be stored in the adapter holder of the
tool. Insert the sport ball needle into the Presta valve
adapter before attaching them to the adapter holder.
3 4
► 1. Sport ball needle 2. Presta valve adapter
3. Adapter holder 4. Tapered adapter
2
1
Storing hose
The hose can be attached to the hose holder of the tool.
2
► 1. Hose holder 2. Hose
Air release button
While the English valve adapter is
NOTICE:
attached to the tool, the air does not go out even
when you press the air release button.
When the object is inflated too much, press the air
release button to release air.
1
► 1. Air release button
8 ENGLISH
1