Preparation - Grundig GKPN 66830LXP Manual De Instrucciones

5. Preparation

Read the "Safety Instructions" section first!
•
For a freestanding appliance;
'this refrigerating appliance is
not intended to be used as a
built-in appliance.
•
Your refrigerator should be
installed at least 30 cm away
from heat sources such as hobs,
ovens, central heater and stoves
and at least 5 cm away from
electrical ovens and should not
be located under direct sunlight.
•
The ambient temperature of
the room where you install
your refrigerator should at
least be +5°C. Operating your
refrigerator under cooler
conditions is not recommended
with regard to its efficiency.
•
Please make sure that the
interior of your refrigerator is
cleaned thoroughly.
•
If two refrigerators are to be
installed side by side, there
should be at least 2 cm distance
between them.
•
When you operate your
refrigerator for the first time,
please observe the following
instructions during the initial six
hours.
•
The door should not be opened
frequently.
•
It must be operated empty
without any food in it.
•
Do not unplug your refrigerator.
If a power failure occurs out
of your control, please see the
warnings in the "Recommended
solutions for the problems"
section.
•
Original packaging and foam
materials should be kept
for future transportations or
moving.
•
The baskets/drawers that
are provided with the chill
compartment must always be in
use for low energy consumption
and for better storage
conditions.
•
Food contact with the
temperature sensor in the
freezer compartment may
increase energy consumption of
the appliance. Thus any contact
with the sensor(s) must be
avoided.
•
In some models, the instrument
panel automatically turns off
1 minutes after the door has
closed. It will be reactivated
when the door has opened or
pressed on any key.
•
Due to temperature change as
a result of opening/closing the
product door during operation,
condensation on the door/body
shelves and the glass containers
is normal.
•
Since hot and humid air will
not directly penetrate into your
product when the doors are
not opened, your product will
optimize itself in conditions
sufficient to protect your food.
Functions and components
such as compressor, fan, heater,
defrost, lighting, display and
so on will operate according
to the needs to consume
minimum energy under these
circumstances.
RO
PL
PT
ES
DE
17