Grundig GKPN 66830LXP Manual De Instrucciones página 7

•
Place the product on a level and
hard surface and balance with
the adjustable legs. Otherwise,
the refrigerator may tip over and
cause injuries.
•
The product shall be installed
in a dry and ventilated
environment. Do not keep
carpets, rugs or similar floor
covers under the product. This
may cause risk of fire as a result
of inadequate ventilation!
•
Do not block or cover ventilation
holes. Otherwise, power
consumption may be increased
and damage to your product
may occur.
•
Do not connect the product to
supply systems such as solar
power supplies. Otherwise,
damage to your product may
occur as a result of the abrupt
voltage fluctuations!
•
The more refrigerant a
refrigerator contains, the bigger
its installation room shall be. In
very small rooms, a flammable
gas-air mixture may occur in
case of a gas leak in the cooling
system. At least 1 m³ of volume
is required for each 8 grams of
refrigerant. The amount of the
refrigerant available in your
product is specified in the Type
Label.
•
The installation place of the
product shall not be exposed to
direct sunlight and it shall not
be in the vicinity of a heat source
such as stoves, radiators, etc.
If you cannot prevent installation of
the product in the vicinity of a heat
source, you shall use a suitable
insulation plate and the minimum
distance to the heat source shall
be as specified below.
8
- At least 30 cm away from
heat sources such as stoves, hea-
ting units and heaters, etc.,
- And at least 5 cm away from
electric ovens.
•
Your product has the protection
class of I. Plug the product in a
grounded socket that conforms
with the Voltage, Current and
Frequency values specified
in the type label. The socket
outlet shall be equipped with a
fuse with a rating of 10 A – 16
A. Our company shall not be
responsible for the damages
that shall be incurred as a result
of operating the product without
ensuring ground and electrical
connections made as per local
or national regulations.
•
The product's power cable
must be unplugged during
installation. Otherwise, risk of
electric shock and injury may
occur!
•
Do not plug the product to loose,
broken, dirty, greasy sockets or
sockets that has come out their
seats or sockets with a risk of
water contact.
•
Place the power cord and hoses
(if available) of the product so
that they shall not cause a risk
of tripping over.
•
Penetration of humidity to live
parts or to the power cord may
cause short circuit. Thus, do
not use the product in humid
environments or in areas
where water may splash (e.g.
garage, laundry room, etc.)
If the refrigerator is wet by
water, unplug it and contact an
authorized service.