Measuring Object/Liquid Temperature - HoMedics NT17 Manual Del Usuario

MEASURING OBJECT/LIQUID
TEMPERATURE
1. Press the Power button to turn the
thermometer on. All symbols on the display
will momentarily appear.
2. Ensure that the thermometer is in Object
mode; the Object symbol will be on the
display. To alternate between modes press
and release the Human/Object Mode
button until you see the desired
measurement symbol on the display.
3. Press and hold the "Scan & measure
button", aiming the Measurement
Sensor at the object, holding the
thermometer approximately
0.5~3 cm.
4. Release the "Scan &
measure button" and the
temperature reading will
be displayed.
5. After about 30 seconds after use,
the thermometer will automatically beep
and shut off.
13
0.5~3 cm
0.5~3 cm
0.5~3 cm
°F
°F
°F