Parts Description; Operation And Maintenance - Tristar SZ-1914 Manual De Usuario

instruction manual

PaRTS DeScRIPTIoN

1. On/Off switch
2. Handle
3. Cord rewind pedal
4. Power regulating switch
5. Front cover
6. Hose Socket
7. Dust bag full indicator
8. Bottom bracket
9. Outlet board
10. Parking hook
11. Wheel
12. Power cord
13. Combi nozzle
14. Tube
15. Hose
16. Wooden floor brush
17. Floor brush
4
13 14
All manuals and user guides at all-guides.com
vacuum cleaner
2
6
7
5
4
1
8
11
15 16 17

oPeRaTIoN aND maINTeNaNce

• Remove all packaging of the device.
• Check if the voltage of the appliance corresponds to the main voltage of
your home. Rated voltage : AC220-240V 50/60Hz
• This vacuum is not designed to collect liquids and sharp items. Never
vacuum hot ashes, make sure it is fully cooled.
FIRST uSe
• Place the vacuum foot (No.16) on the telescope tube (No.14) The telescope
tube length can be made, according to your wishes, by pressing the button
down and push the tube to extend or reduce. Place the tube (No.15) with
the side of the hose coupling) in front of the vacuum, if you hear a click,
this just confirmed. To disconnect the hose press the button of the hose
3
coupling. Pull out the main cable to the full length and plug into the main
supply. Note that you don't exceed the red mark when pulling out the cord.
The yellow mark shows you the ideal length of the cable.
• Using the button on the vacuum foot in the desired position, with or
9
without a brush on the bottom of the suction foot.
• Always make sure that all the filters and the dust bag are correctly fitted
before using the appliance. Damaged or incorrectly fitted filters or dust bag
may cause damage to the appliance.
uSe
10
• Pull the plug from the vacuum cleaner and place it into a wall outlet. Press
the ON/OFF button and start your vacuum cleaner.
12
• The air regulator (No.4) controls the suction if it should be temporarily
reduced.
• To turn the unit off, press the ON / OFF button. Unplug the power cord and
press the cable rewind button (No. 3). You can use the storage clip to store
the vacuum bar when you store the vacuum cleaner.