Function Buttons And Display; Switching On Or Commissioning; Display Function Modes; Parameter Display Mode - Roger CTRL Instrucciones Y Advertencias Para El Instalador

8

Function buttons and display

UP
DOWN
PROG
• Press the UP and/or DOWN
• Use the + and -
• Press and hold the + or - button to scroll quickly through values, to modify the parameter more quickly.
• To save the new value, wait a few seconds or move onto another parameter with the UP
•
9

Switching on or commissioning

Power the control unit.
Version installed P4.10.
Immediately afterwards, the displays enters the commands and safety device status mode. See chapter 10.
For installations with two opposing barriers, settings must be made from the MASTER controller. Only the parameters
and
10

Display function modes

10.1

Parameter display mode

PARAMETER
PARAMETER
See chapter 12 for detailed descriptions of parameters.
TEST
buttons to view the parameter you intend to modify.
VALUE
BUTTON DESCRIPTION
UP Next parameter
DOWN Previous parameter
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Travel acquisition
TEST Activate TEST mode
or DOWN button. The
73