Start-Up; Maintenance; Disposal; Additional Information And Contact Details - Roger CTRL Instrucciones Y Advertencias Para El Instalador

20

Start-up

contain the wiring diagram, the drawing and the photo of the system, the risk analysis and the solutions adopted, the
manufacturer's declaration of conformity for all connected devices, the instructions manual of each device and / or
accessory and the system's maintenance plan.
Apply a plate indicating the automation system data on the motorised door or gate, the name of the person in charge
of the start-up, the serial number and the year of construction, as well as the CE mark.
Apply a plate and / or label with the indications for the operations required to manually unlock the system.
Draw up and provide the end user with the declaration of conformity, instructions and warnings for use and the
maintenance plan.
Make sure that the end user has understood the correct automatic, manual or emergency operation of the system.
Inform the end user about the dangers and risks that may be present.
21

Maintenance

Perform scheduled maintenance every 6 months.
Check cleanliness and function.
If the unit contains dirt, moisture, insects or other foreign matter, disconnect from mains power and clean the board
and the housing.
Repeat the initial installation test procedure after cleaning.
If any corrosion is found on the printed circuit board, evaluate if it is necessary to replace the board itself.
Make sure the batteries are in good working order (if installed).
22

Disposal

suitable procedures for removing the product correctly and safely.
This product consists of numerous different materials.
Some of these materials may be recycled, while others must be disposed of correctly
applicable for this category of product.
Do not dispose of this product as domestic refuse.
Observe local legislation for differentiated refuse collection, or hand the product over to the
vendor when purchasing an equivalent new product.
Warning! some parts of this product may contain substances that are harmful to the
environment or dangerous and which may cause damage to the environment or health risks if
disposed of incorrectly.
23

Additional information and contact details

ROGER TECHNOLOGY is the exclusive proprietor holder of all rights regarding this publication.
or any alterations to this document are prohibited without express prior authorised from by ROGER TECHNOLOGY.
This instruction manual and the warnings for the installer are given in printed form and included in the box containing
the product.
The digital version of this documentation (in PDF format) and all future revisions are available from the reserved area
of our website www.rogertechnology.com/B2B, in the section 'Self Service'.
ROGER TECHNOLOGY CUSTOMER SERVICE:
97