Roger CTRL Instrucciones Y Advertencias Para El Instalador página 89

N.B.
HW version
Year of manufacture
Week of manufacture
Serial number
FW version
RS485 serial communication version
View manoeuvre counter
The number consists of the values of the parameters from
N.B.
Manoeuvres performed
x100 = 1,234,500 manoeuvres
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.
Manoeuvre hours
= 123 hours
View control unit days on counter
The number consists of the values of the parameters from
N.B.
Days with unit switched on
= 123 days
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (
Only a single password is used to control access to the barrier automation system.
WARNING: Contact the Technical Support Service if you lose your password.
N.B.: This parameter is not visible for the SLAVE barrier.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
•
• Switch the control unit off and on again. Check that password protection is activated ( =
Temporary unlock procedure:
• Enter the password.
• Check that = .
Password cancellation procedure:
• Enter the password ( =
• Save the values , ,
• Use the UP and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
•
and indicate that no password is set).
• Switch the control unit off and on again (
Password change protection
Protection deactivated.
Protection activated.
=
, , and
buttons to view parameter
).
, =
buttons to view parameter
= ).
to
to multiplied by 100.
to .
to .
.
.
.
.
).
, , and
89