Haier HSU-09H03/R2 Manual De Funcionamiento página 16

Operation
(5)Air flow direction adjustment
After operation mode is selected, vertical flap will open automatically according to the mode.
Referring to the Fig.
COOL
About 10
Up and down (Use remote controller)
Press SWING button, vertical flap will move within
the range shown in the Fig. Press SWING button
stop it at a fixed position.
About 10
COOL About 45
HEAT
About 60
Cautions:
It is advisable not to keep vertical flap at
downward position for a long time in COOL
or DRY mode, otherwise, condensate
water might occur.
(6)Unit stop
Press ON/OFF button.
Hints
As cold air flows downward in COOL mode, adjusting air flow horizontally will be much more
helpful for a better air circulation.
As warm air flows upward in HEAT mode, adjusting air flow downward will be much more
helpful for a better air circulation.
Be careful not to catch a cold when cold air blows downward.
It is harmful to your health in summer to go frequently in and out of places where temp.
o
difference is above 7
More than this, unit's load can be reduced and power consumption cut down as well. So, you'd
better set a temp. difference of 3-5
All manuals and user guides at all-guides.com
o
o
o
o
o
C. Temp. difference of 3-5 C will remove your fatigue.
o
C between indoor and outdoor temp. in COOL mode.
14
HEAT
About 60
o
Left and right air flow adjustment
(manual)
Move the horizontal blade by a knob on air
conditioner to adjust left and right direction
referring to Fig.
Cautions:
When humidity is high, condensate water
might occur at air outlet if all horizontal
louvers are adjusted to left or right.
Cautions:
Unit won't restart until 3 minutes have
elapsed, due to system protection.
HEAT mode is not available on
cooling only unit.