Functional Description - Makita DML805 Manual De Instrucciones

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off, unplugged,
and the battery cartridge is removed before carrying out
any work on the tool.
Assembling the frame and the base
1
3
Assemble the worklight as follows:
1. Remove the screws.
2. Insert the legs of the frame into the base.
3. Align the holes of the frame and the base.
4. Tighten them with screws.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off, unplugged,
and the battery cartridge is removed before adjusting or
checking function on the tool.
Use with battery:
Installing or removing battery cartridge
CAUTION:
• Always switch off the tool and unplug before installing
or removing of the battery cartridge.
• Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge. Failure to
hold the tool and the battery cartridge firmly may cause
them to slip off your hands and result in damage to the
tool and battery cartridge and a personal injury.
3
To install the battery cartridge, release the cover lock, and
open the battery cover. And insert the battery cartridge.
Align the tongue on the battery cartridge with the groove
in the housing and slip it into place. Insert it all the way
until it locks in place with a little click. Then close the
battery cover.
1. Frame
2. Base
3. Screw
2
1. Cover lock
2. Battery cover
3. Battery cartridge
2
1
To remove the battery cartridge, slide it from the tool while
sliding the button on the front of the cartridge.
CAUTION:
• Always install the battery cartridge fully in place. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
• Do not install the battery cartridge forcibly. If the
cartridge does not slide in easily, it is not being inserted
correctly.
Use with AC power:
Connect the plug to a power supply.
Turning on LED light
Press the switch once, the light shines brightly (high
mode). Press the switch again, the light shines mildly (low
mode). To turn off the light, press the switch once again.
Battery protection system
The tool is equipped with a battery protection system to
extend battery life.
When the battery becomes low, the LED lights go out
except one LED (the one on the second line center).
Then, after approximately five to ten minutes later, the
system automatically cuts off power.
1. Plug (the shape
may differ from
country to country)
1
1. Switch
1
5