Mounting The Bar And Chain (Side Chain Tensioner) - Stihl MS 170 Manual De Instrucciones

Mounting the Bar and Chain
(side chain tensioner)
Removing the chain sprocket cover
Unscrew nuts and remove chain
N
sprocket cover
1
2
Turn screw (1) to the left until the
N
tensioner slide (2) butts against the
left end of the housing slot
MS 170, MS 170 C, MS 180, MS 180 C
Releasing the chain brake
Pull hand guard towards the front
N
handle until it engages audibly –
chain brake is released
Fitting the saw chain
WARNING
Put on protective gloves – risk of injury
by the sharp cutters
Fit the chain starting at the nose of
N
the guide bar
1
3
1
2 4
Position the guide bar over the
N
bolts (1) – the cutting edges of the
saw chain must point to the right
Position the locating hole (2) over
N
the peg of the tensioner slide –
simultaneously place the saw chain
over the sprocket wheel (3)
Turn screw (4) to the right until there
N
is very little chain sag on the
underside of the bar – and the drive
link tangs engage in the bar groove
Refit the chain sprocket cover – and
N
then screw on the nut by hand until
it is fingertight
Go to chapter "Tensioning the saw
N
chain"
English
29