Storing The Machine; Checking And Replacing The Chain Sprocket - Stihl MS 193 T Manual De Instrucciones

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove the saw chain and guide
N
bar, clean them and spray with
corrosion inhibiting oil.
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
If you use a biological chain and bar
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry, high or
N
locked location, out of the reach of
children and other unauthorized
persons.
MS 193 T
Checking and Replacing the
Chain Sprocket
Remove the chain sprocket cover,
N
chain and guide bar.
Disengage the chain brake: Pull the
N
hand guard towards the front
handle.
Replace the chain sprocket:
after using two saw chains or
–
sooner
if the wear marks (arrows) on the
–
sprocket are deeper than about
0.5 mm (0.02 in) since this would
reduce the life of the chain. You can
use a gauge (special accessory) to
check the depth of the wear marks.
It is best to use two saw chains in
rotation with one sprocket.
STIHL recommends the use of original
STIHL sprockets to ensure correct
operation of the chain brake.
Removing
2
Remove the spark plug boot (1).
N
Unscrew the spark plug (2).
N
3
2.
Insert the locking strip (3) sideways
N
in the cylinder (1) and then turn it
through 90° (2).
Rotate the clutch clockwise as far as
N
stop
Loosen the clutch hexagon
N
clockwise (left-hand thread).
Unscrew the clutch.
N
English
1.
39