Specifications - Stihl HL 45 Manual De Instrucciones

Definitions
1 Loop Handle
For easy control of machine during
cutting work.
2 Stop Switch
Switches the engine's ignition off
and stops the engine.
3 Throttle Trigger Lockout
Must be depressed before the
throttle trigger can be activated.
4 Throttle Trigger
Controls the speed of the engine.
5 Choke Lever
Eases engine starting by enriching
mixture.
6 Filter Box Cover
Covers the air filter.
7 Fuel Filler Cap
For closing the fuel tank.
8 Fuel Tank
For fuel and oil mixture.
9 Machine Support
For resting machine on the ground.
10 Cutter Blades
Steel blades for cutting hedges and
shrubs.
11 Guide Guard
Protects the tip of the blade when
working near ground level.
12 Blade Scabbard
Covers cutter blade when hedge
trimmer is not in use.
HL 45
13 Cutting Blade Guard
Helps to reduce the risk of operator
contact by the cutter blade.
14 Blade Drive Gear
Converts rotary movement of angle
drive into reciprocating movement
of cutting blades.
15 Angle Drive
Transmits rotary motion of drive
shaft to the blade drive gear.
16 Drive Tube
Encloses and protects the drive
shaft between the engine and
gearbox.
17 Manual Fuel Pump
Provides additional fuel feed for a
cold start.
18 Carburetor Adjusting Screws
For tuning the carburetor.
19 Starter Grip
The grip of the pull starter, for
starting the engine.
20 Spark Plug Boot
Connects the spark plug with the
ignition lead.
21 Muffler with Spark Arresting Screen
Muffler reduces exhaust noises and
diverts exhaust gases away from
operator. Spark arresting screen is
designed to reduce the risk of fire.

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
Single cylinder two-stroke engine
Displacement: 1.66 cu. in.
(27.2 cm
Bore: 1.34 in. (34 mm)
Stroke: 1.18 in. (30 mm)
Engine power to 1 HP (0.75 kW) at
ISO 8893: 7,000 rpm
Idle speed: 2,800 rpm
English
3)
27