NOZZLE COLOR SPRAY PATTERN USES
White
Black
*NOTICE: The high pressure spray from your pressure washer is capable of
causing damage to surfaces such as wood, glass, automobile paint, auto striping
and trim, and delicate objects such as flowers and shrubs. Before spraying, check
the item to be cleaned to assure yourself that it is strong enough to resist damage
from the force of the spray.
CHANGING NOZZLES ON SPRAY WAND
DANGER: Risk of fluid injection. Do not direct discharge stream toward
persons, unprotected skin, eyes or any pets or animals. Serious injury will
occur.
WARNING: Flying objects could cause risk of serious injury. Do not
attempt to change nozzles while pressure washer is running. Turn engine off
before changing nozzles.
1.
Pull quick-connect coupler (S) back and insert nozzle (K).
2.
Release quick-connect coupler and twist nozzle to make
sure it is secure in coupler.
WARNING: Flying object could cause risk of serious
injury. Ensure nozzle is completely inserted in quick-
connect socket and quick-connect snap ring is fully
engaged (forward) before squeezing gun trigger.
HOW TO APPLY CHEMICALS/CLEANING SOLVENTS (FIG. 7)
Applying chemicals or cleaning solvents is a low pressure operation. NOTE: Use
only soaps and chemicals designed for pressure washer use. Do not use bleach.
To Apply chemicals:
1.
Press detergent siphon hose (F) onto barbed fitting
located near high pressure hose connection of
pump as shown.
2.
Place other end of detergent siphon hose with
filter on it into container holding chemical/cleaning
solution. NOTE: For every 7 gallons of water
pumped 1 gallon of chemical/cleaning solution will
be used.
3.
Install low pressure (black) nozzle into quick connect fitting of spray wand, see
How To Use Spray Wand paragraph in this section.
4.
After use of chemicals, place detergent siphon hose into container of clean
water and draw clean water through chemical injection system to rinse system
thoroughly. If chemicals remain in the pump it could be damaged. Pumps
damaged due to chemicals will not be covered under warranty.
40˚
low pressure
cleaning of
painted or delicate
surfaces
applies cleaning
solutions
13 - ENG
SURFACES*
auto/RV, marine, wood,
painted brick and stucco,
vinyl, painted siding
low pressure spray is
safe on all surfaces.
Always verify
compatibility of cleaning
solution prior to use
K
S
7
F
6