Before Returning For Repairs; Specifications - Schumacher Electric SC9 Manual Del Usuario

PROBLEM
The BAD BATTERY LED
is lit.

14. BEFORE RETURNING FOR REPAIRS

For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP
UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number
from Customer Service at Schumacher Electric Corporation.

15. SPECIFICATIONS

Input ..................................................................120V AC, 0.6A Continuous, 3A Intermittent
Output ................................................................... 12V DC, 2A Continuous, 10A Intermittent
POSSIBLE CAUSE
The battery is sulfated.
Lack of progress is detected
and battery voltage is below
14.2V.
The battery's initial voltage
is below 12.2V and the total
input is less than 1.5 Ah.
The battery voltage drops
to below 12.2V in Maintain
Mode.
If these solutions do not eliminate the problem,
or for more information about troubleshooting,
contact customer service for assistance:
services@schumacherelectric.com
www.batterychargers.com
or call 1-800-621-5485
Monday-Friday 7:00
55 Seconds Maximum On, 120 Seconds Minimum Off
The charger is in desulfation
mode. Continue charging for
several hours. If not successful,
have the battery checked.
The battery may be overheated.
If so, allow the battery to cool.
The battery may be too large or
have a short circuit. Have battery
checked or replaced.
The battery capacity is too low,
or the battery is too old. Have it
checked or replaced.
The battery won't hold a charge.
May be caused by a drain on
the battery or the battery could
be bad. Make sure there are no
loads on the battery. If there are
remove them. If there are none,
have the battery checked or
replaced.
to 5:00 CST
am pm
• 9 •
REASON/SOLUTION