Messages - Sony DSX-A410BT Manual De Instrucciones

No sound is output from the car speakers during
handsfree call.
 If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
car speakers.
Siri Eyes Free is not activated.
 Perform the handsfree registration for an iPhone
that supports Siri Eyes Free.
 Set the Siri function on the iPhone to on.
 Cancel the BLUETOOTH connection with the
iPhone and the unit, and reconnect.
Sony | Music Center operation
Application name is mismatched with the actual
application in "Sony | Music Center".
 Launch the application again from the "Sony |
Music Center" application.
While running the "Sony | Music Center"
application via BLUETOOTH, the display
automatically switches to [BT AUDIO].
 The "Sony | Music Center" application or
BLUETOOTH function has failed.
 Run the application again.
The "Sony | Music Center" application is
automatically disconnected when the display
switches to [IPOD].
 The "Sony | Music Center" application on iPhone/
iPod does not support iPod playback.
 Change the source of the unit to other than
[IPOD], then establish the "Sony | Music
Center" connection (page 17).
The "Sony | Music Center" connection is
automatically disconnected when the USB mode
of the unit is changed to [ANDROID].
 The Android smartphone is not supporting
playback in Android mode.
 Set the USB mode of the unit to [MSC/MTP],
then establish the "Sony | Music Center"
connection (page 17).

Messages

The following messages may appear or flash during
operation.
HUB NO SUPRT: USB hubs are not supported.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during iPod
playback.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA (Android Open
Accessory) 2.0 is connected to the unit while [USB
MODE] is set to [ANDROID].
 Set [USB MODE] to [MSC/MTP] (page 20).
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC to
select another source.
 The USB device has a fault, or an unsupported
device is connected.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable files
(page 24).
USB NO SUPRT: The USB device is not supported.
 For details on the compatibility of your USB
device, visit the support site (page 36).
29
GB