Installation Instructions; Tools Needed; Additional Parts Required - Haier RDE350AW Manual Para El Usuario

INSTALLATION INSTRUCTIONS

Risk of Fire
Clothes dryer installation must be performed by a quali ed installer.
Install the clothes dryer according to the manufacturer's instructions
and local codes.
To reduce the risk of severe injury or death, follow all installation
instructions.

TOOLS NEEDED

• Phillips Screwdriver
• Flat-Blade Screwdriver
• Channel-Lock Adjustable Pliers
• ½" Open-End Wrench
• Carpenter's Level
• Measuring Tape (12 ft. [3.7 m] min.)

ADDITIONAL PARTS REQUIRED

• 4" (10.2 cm) Rigid or Flexible Metal Exhaust Ducting
• Vent Clamps
• Duct Tape
• Power Cord (US Electric Dryer Only)
- A power supply cord kit must be purchased to meet local electrical codes.
The dryer must use a 3 or 4-wire NEMA 14-30 or 10-30 type SRDT or ST
(as required) power supply cord rated at 120/240 volt AC minimum,
30 amp, with 3 open-end spade lug connectors with upturned ends or
closed loop connectors and marked for use with clothes dryers.
- UL Listed Strain Relief
• Gas Hookup Parts (Gas Dryer Only)
- " NPT Elbow
- " NPT Flare Adapter Fitting
- " Flexible Gas Connector
- Pipe-Joint Compound
• Mobile Home Installation Kit (Gas Dryer for Mobile Home Only)
6
WARNING
For gas installations only:
• Pipe Wrench
• 2 Adjustable Wrenches