Health And Safety; Observations; Warranty Conditions - Sagola MACK 400 Manual De Instrucciones, Lista De Repuestos

PIn order to carry out maintenance, repairs or cleaning, first
disconnect the unit from the air supply, after having correctly
carried out the DEPRESSURISATION procedure described in
Section 10 of the Manual.
Never point the unit towards yourself, other personnel or animals.
The thinners and dilution media used can cause serious injury.
With this unit the product is sprayed at a very high pressure. The
stream coming from the gun, from leaks, or due to the breakage
of a component in the unit, could cause the product to be injected
at high pressure under the skin. LIkewise if the product is sprayed
or splashed in the eyes it can cause serious harm.
Never attempt to stop the application stream or a leak with your
hand or any other part of your body. If you suspect you may have
sprayed the product on your skin, IMMEDIATELY SEEK MEDICAL
ATTENTION. This incidence must not be treated as a simple cut.
Describe the product with which it ocurred to the Doctor in as
much detail as possible.
The location where work is carried out must have sufficient
ventilation in accordance with current legislation and regulations.
Near the unit, only keep the amount of product and thinner required
for the work being done at that time. After work has been
completed, thinners and the product to be applied must be returned
to their corresponding storage location.
Keep the working area clean and free of potentially dangerous
waste (thinners, rags, etc.)
While work is in progress, there must not be any source of ignition
(naked flames, lighted cigarettes, etc.) in the working area as
these might generate easily flammable gases. Likewise, the
approved protective means must be used (breathing, hearing,
etc.) in accordance with the regulations established in this regard.
If the unit is used in an inadequate manner or its components are
altered in any way, severe material damage may occur and bodily
harm may be caused to the operator, other personnel and/or
animals and may even cause death. SAGOLA, S.A.U. accepts
no responsibility in for any damage caused through the incorrect
use of the unit.
Always use approved breathing units in accordance with current
standards and regulations in order to protect yourself from
emissions produced during application.
By following the instructions set out in this manual you will
ensure good spraying and quality of finish.
This device has been manufactured with great precision and
has been subjected to a large number of controls before leaving
the factory.
The WARRANTY is valid for three years, counted as of the date
of purchase, which will be indicated by the seller in the place
provided for this purpose, together with his stamp.
Once the unit has been received, please complete the warranty
and send this to the manufacturer for validation.
This WARRANTY covers any manufacturing defect, which will
be repaired free of charge. However, any malfunction resulting
from the incorrect use of the unit, such as inadequate connections,
breakage due to dropping, or similar, the normal wear of
components and in general any deficiency not attributable to the
manufacturer of the device, are expressly excluded. Likewise,
the WARRANTY shall be rendered null and void when it is evident
that the unit has been handled by persons other than our
Technical Assistance Service.

16. HEALTH AND SAFETY

17. OBSERVATIONS

18. WARRANTY CONDITIONS

- 21 -
Never exceed the maximum operation pressure. The units are
calibrated by the manufacturer in accordance with the design
specifications described in its characteristics.
As a general preventive measure we advise you to wear goggles
in accordance with the specific environmental regulations and
characteristics for the work centre.
Use gloves when handling the product (see the manufacturer's
recommendations) and cleaning the gun.
If, when the equipment is in use, the ambient noise level exceeds
90 dB. the use of approved hearing protection is recommended.
The equipment in itself does not propitiate any mechanical risk
of perforations, impact or pinching, except those deriving from
incorrect installations and handling.
USE SAGOLA ANTISTATIC HOSES TO ELIMINATE POSSIBLE
ELECTRICAL DISCHARGES THAT MIGHT CREATE THE RISK
OF FIRE OR EXPLOSION.
Pay adequate attention when handling the unit in order to prevent
any damage that might lead to dangerous situations for the user
or personnel standing near the unit, as a consequence of leaks,
breakages, etc.
The equipment has been designed for use at ambient temperature.
The maximum operating temperature is 50
The use of solvents and/or detergents that contain halogenated
hydrocarbons (trichloroethane, methyl chloride, etc.), may cause
chemical reactions in the unit as well as in its zinc-coated
components (trichloroethane mixed with small amounts of water
produces hydrochloric acid). For this reason, these components
may rust and in extreme cases the chemical reaction caused may
be explosive. We recommend you use products that do not contain
the aforementioned components. Do not use acids, soda (alkalis
or pickling substances, etc.) for cleaning under any circumstances.
In general, precautions must be taken whenever the unit is
handled, in order to prevent any deterioration to it.
Connectors must be securely tightened and in good condition.
Safety standards must be understood and applied.
Any non-compliance with the indications set out in this manual
may lead to incidents affecting the physical integrity of the user
or other personnel or animals.
Respect and comply with indications relating to the conservation
of the environment.
Should you have any doubts, please contact SAGOLA S.A.
Customer Service.
This WARRANTY does not support any undertaking made by
anyone outside our Technical Service.
In the case of any breakdown during the guarantee period, please
attach the completed warranty certificate to the unit and deliver
this to the nearest Technical Assistance Service or get in touch
with the factory.
Any demand of greater importance against the supplier, in
particular compensation for damages, is excluded. This is also
applicable to any damages that might arise during counselling,
while acquiring practice and during demonstration.
Consequently, the services rendered under guarantee do not
involve an extension of the warranty period.
Any device for which there is no duly completed guarantee
certificate in the files of SAGOLA S.A. will be rejected.
The manufacturer reserves the right to make technical
modifications.
o
C.