Cleaning And Maintenance - Cuisinart CPT-620 Manual De Instrucciones

Single Slice Button
The Single Slice Function evenly toasts one slice of bread, side to side.
1. Insert slices of bread.
Be sure that the carriage is in the up position.
2. Select bread type.
3. Set browning control.
4. Press the carriage control level until it locks into position.
5. Press the Single Slice button. Blue LED indicates feature is active.
To Stop Cycle
When the Single Slice cycle is complete, the toaster will raise the bread. If you
wish to stop the cycle before it is finished, simply touch the Cancel button to
interrupt. After use, unplug the toaster from the electrical outlet.
Defrost Button
The Defrost button is designed to first defrost and then toast the bread to your desired
browning shade.
1. Insert slice(s) of bread.
Be sure that the carriage is in the up position.
2. Select bread type.
3. Set the browning control.
4. Press the carriage control lever until it locks into position.
5. Push the Defrost button. Blue LED indicates feature is activated.
To stop cycle
When the Defrost cycle is complete, the toaster will raise the bread. If you wish
to stop the cycle before it is finished, simply touch the Cancel button to interrupt.
After use, unplug the toaster from the electrical outlet.

CLEANING AND MAINTENANCE

Always allow the toaster to cool completely before cleaning.
1. Always unplug the toaster from the electrical outlet before cleaning.
2. Do not use abrasive cleaners. Simply wipe the exterior with a clean, damp cloth
and dry thoroughly.
3. To remove crumbs, slide out the crumb tray and discard crumbs. Wipe clean and
replace. Never operate the toaster without the crumb tray in place.
4. To remove any pieces of bread remaining in the toaster, turn the toaster upside
down and gently shake. Never insert any hard or sharp instruments into the slots,
as this could damage the toaster and cause a safety hazard.
5. Never wrap the cord around the outside of the toaster.
Use the cord storage cleats on the underside of the toaster.
6. Any other servicing should be performed by an authorized service representative.
5