Cleaning And Maintenance - Cuisinart CPT-420 Manual De Instrucciones

Bagel button
The bagel feature reduces heat on one side of the toasting slot.
This toasts the cut side of the bagel slightly more than the other side.
An embossed icon located on the top of the toaster, just above
the control panel, shows you the right way to insert your bagel.
(The cut side should always facetoward the center of the toaster.)
1. Insert slice(s) of bread or halved bagels.
Be sure that carriage is in the up position.
2. Select browning control.
3. Press the Bagel button. Blue LED indicates feature is activated.
4. Press the toast button to start.
To stop cycle
When the bagel cycle is complete, the toaster will raise the bagel(s).
If you wish to stop the cycle before it is finished, simply press the Cancel
button to interrupt. After use, unplug your toaster from the electrical outlet.
Defrost button
The Defrost button is designed to first defrost and then toast the bread, which
extends the toasting cycle slightly.
1. Insert slice(s) of bread.
Be sure that the carriage is in the up position.
2. Select browning control.
3. Press the Defrost button. Blue LED indicates feature is
activated.
4. Press the toast button to start.
To stop cycle
When the defrost cycle is complete, the toaster will raise the bread. If you
wish to stop the cycle before it is finished, simply press the Cancel button to
interrupt. After use, unplug the toaster from the electrical outlet.
Reheat button
The reheat feature allows you to reheat bread without browning or toasting it.
1. Insert slice(s) of bread.
Be sure that the carriage is in the up position.
2. Press the Reheat button. Blue LED indicates feature is activated.
3. Press the toast button to start.
To stop cycle
When the reheat cycle is complete, the toaster will raise the bread. If you
wish to stop the cycle before it is finished, simply press the Cancel button to
interrupt. After use, unplug your toaster from the electrical outlet.
Fail-Safe
• Should the unit sense that it is over-heating it is designed to activate a
"Fail-Safe" to ensure it can cool down quickly and be able to return to a safe,
usable state.
• When the Fail-Safe is activated all the LCD and LED lights will come on and
the unit will sound (3) one-second audible tones. The LCD and LED lights will
remain on until the unit is unplugged and re-plugged into the outlet.

CLEANING AND MAINTENANCE

Always allow the toaster to cool completely before cleaning.
1. Always unplug the toaster from the electrical outlet before cleaning.
2. Do not use abrasive cleaners. Simply wipe the exterior with a clean damp
cloth and dry thoroughly. Apply any cleaning agent to a cloth, not to the
toaster, before cleaning.
3. To remove crumbs, slide out the crumb tray and discard crumbs. Wipe clean
and replace. Never operate the toaster without the crumb tray in place.
4. To remove any pieces of bread remaining in the toaster, turn the toaster
upside down and gently shake. Never insert any hard or sharp instruments
into the slot, as this could damage the toaster and cause a safety hazard.
5. Never wrap the cord around the outside of the toaster. Use the cord storage
cleats on the underside of the toaster.
6. Any other servicing should be performed by an authorized service
representative.
5