Cleaning And Maintenance - Cuisinart CPT-160 SERIE Manual Del Usuario

Defrost Button
The "Defrost" button is designed to first defrost and then toast the bread,
which extends the toasting cycle slightly.
1. Insert slice(s) of bread.
Be sure that the carriage is in the up position.
2. Set the Browning Control.
3. Press the Carriage control lever until it locks into position.
4. Press the "Defrost" button. Red LED indicates feature
is activated.
To stop cycle: When the defrost cycle is complete, the toaster will raise the
bread. If you wish to stop the cycle before it is finished, simply press the
"Cancel" button to interrupt. After use, unplug the toaster from the electrical
outlet.
Reheat Button
The reheat feature allows you to reheat bread without browning or toasting.
1. Insert slice(s) of bread.
Be sure that the carriage is in the up position.
2. Press the carriage control lever until it locks into position.
3. Press the "Reheat" button. Red LED indicates feature
is activated.
To stop cycle:
When the defrost cycle is complete, the toaster will raise the bread. If you
wish to stop the cycle before it is finished, simply press the "Cancel" button
to interrupt. After use, unplug the toaster from the electrical outlet.

CLEANING AND MAINTENANCE

Always allow the toaster to cool completely before cleaning.
1. Always unplug the toaster from the electrical outlet.
2. Do not use abrasive cleansers. Simply wipe the exterior with a clean
damp cloth and dry thoroughly. Apply any cleansing agent to a cloth,
not to the toaster, before cleaning.
3. To remove crumbs, slide out the crumb tray and discard crumbs. Wipe
clean and replace. Never operate the toaster without the crumb tray
in place.
4. To remove any pieces of bread remaining in the toaster, turn the
toaster upside down and gently shake. Never insert any hard or sharp
instruments into the slot, as this could damage the toaster and cause
a safety hazard.
5. Never wrap the cord around the outside of the toaster. Use the cord
storage cleats on the underside of the toaster.
6. Any other servicing should be performed by an authorized
service representative.
5