Cleaning And Maintenance - Cuisinart CPT-435 Serie Manual De Instrucciones

Bagel button
The Bagel feature reduces heat on one side of the toasting slot.
This toasts the cut side of the bagel slightly more than the other side.
An embossed icon located on the top of the toaster,
just above the control panel, shows you the right way
to insert your bagel. (The cut side should always face
toward the center of the pair of toasting slots.)
1. Insert slice(s) of bread or halved bagels.
Be sure that the carriage is in the up position.
2. Select the browning control.
3. Press the Bagel button. Blue LED indicates feature is activated.
4. Press the carriage control lever until it locks into position.
To stop cycle
When the Bagel cycle is complete, the toaster will raise the bread.
If you wish to stop the cycle before it is finished, simply press the Cancel
button to interrupt. After use, unplug the toaster from the
electrical outlet.
Defrost button
The Defrost button is designed to first defrost and then toast the bread, which
extends the Toasting cycle slightly.
1. Insert slice(s) of bread.
Be sure that the carriage is in the up position.
2. Select the browning control.
3. Press the Defrost button. Blue LED indicates feature is activated.
4. Press the carriage control lever until it locks into position.
To stop cycle
When the Defrost cycle is complete, the toaster will raise the bread. If you
wish to stop the cycle before it is finished, simply press the Cancel button
to interrupt. After use, unplug the toaster from the electrical outlet.
Reheat button
The reheat feature allows you to reheat bread without browning
or toasting.
1. Insert slice(s) of bread.
Be sure that the carriage is in the up position.
2. Press the Reheat button. Blue LED indicates feature is activated.
3. Press the carriage control lever until it locks into position.
To stop cycle
When the Reheat cycle is complete, the toaster will raise the bread. If you
wish to stop the cycle before it is finished, simply press the Cancel button
to interrupt. After use, unplug the toaster from the electrical outlet.

CLEANING AND MAINTENANCE

Always allow the toaster to cool completely before cleaning.
1. Always unplug the toaster from the electrical outlet before cleaning.
2. Do not use abrasive cleaners. Simply wipe the exterior with a clean, damp cloth
and dry thoroughly. Apply any cleaning agent to a cloth, not to the toaster, before
cleaning.
3. To remove crumbs, slide out the crumb tray and discard crumbs. Wipe clean and
replace. Never operate the toaster without the crumb tray in place.
4. To remove any pieces of bread remaining in the toaster, turn the toaster upside
down and gently shake. Never insert any hard or sharp instruments into the slots,
as this could damage the toaster and cause a safety hazard.
5. Never wrap the cord around the outside of the toaster. Use the cord storage
cleats on the underside of the toaster.
6. Any other servicing should be performed by an authorized service
representative.
5