Installation - Sony WX-900BT Manual De Instrucciones

Installation

Mounting the unit in the dashboard
When mounting in a Japanese car, see "Mounting
the unit in a Japanese car" (page 31).
Mounting the unit with an installation kit
(not supplied)
You can use a commercially available double DIN
installation kit. Choose an installation kit with the
following panel frame size.
Larger than 172 × 97 mm (6
an inner corner radius of less than 0.5 mm (
Note
Be sure to use the supplied screws .

Larger than
7
97 mm (3 / in)
8
Larger than
7
172 mm (6 / in)
8
Installation kit (not supplied)
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.

to dashboard/center console
Bracket
Existing parts supplied
with your car
7 / × 3 7 / in) (w/h), with
8 8
1 / in).
32
to dashboard/center console


Bracket
When mounting this unit to the preinstalled
brackets of your car, use the supplied screws  in
the appropriate screw holes, based on your car: T
for TOYOTA, M for MITSUBISHI and N for NISSAN.
Note
To prevent malfunction, install only with the supplied
screws .
Resetting the unit
For details, see "Resetting the unit" (page 7).
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
Fuse (10 A)
31
GB