Set Up / Batteries - Health O Meter 499KL Instrucciones De Uso

Balanza electrónica a la altura de la cintura

Ocultar thumbs Ver también para 499KL:

Idiomas disponibles

SET UP / BATTERIES

INSTALLING BATTERIES

Locate the battery compartment on the back of the display head.

With a Phillips screwdriver remove the screw from the battery compartment cover and remove cover.

Place 6 new AA alkaline batteries into the battery compartment. Make sure the '+' and '-' are positioned correctly, as shown on the

bottom of the battery compartment. Replace the batteries when the display reads 'LobAt' (Use only 6 AA alkaline batteries).

Replace the battery compartment cover.

NOTE: Dispose used batteries in accordance to your country's national, state or local requirements.

OPERATION WITH ADAPTER POWER

Plug the optional adapter (NOT INCLUDED) into the base of the scale and then into the outlet for power. Please refer to page 3 for

information regarding the adapters available for use with this scale. When an adapter is used, the battery icon will not be displayed.

The location of the adapter power jack on the scale (C) is shown below in Figure 1.

ASSEMBLING AND PREPARING THE SCALE FOR USE

Locate cable inside the upper column (A) and then feed it through the lower column (B).

After the cable is fed through (B), then plug the cable into the scale base (C).

Connect columns (A) and (B), then secure to base (C), using the 4 screws provided (see Figure 1).

Turn the scale on by pressing the ON/OFF button. The display will show "Start" and then "0.0".

NOTE: If set up instructions failed, refer to the troubleshooting instructions. If troubleshooting does not resolve the problem,

please contact Health o meter® Professional Technical Support at 1-800-638-3722.

Figure 1

499KL

Tabla de Contenido