Set Up / Batteries - Health O Meter 500KL Instrucciones De Uso

SET UP / BATTERIES

Preparing the 500KL Scale for Use / Inserting Batteries
1. Remove the protective plastic film covering the display (the film says "FACTORY
CALIBRATED").
2. Unplug the optional AC adapter, if connected to a power source.
3. With a Phillips head screwdriver remove the screw from the battery compartment cover
located on the back of the display. Remove the battery cover by pressing downward on the
locking tab.
4. Replace or install 6 new AA batteries. Health o meter
alkaline or lithium battery, rated for 130°F (54°C) operation. Do not use zinc-carbon batteries.
5. Re-attach the battery cover to the display assembly.
6. Ensure all objects are removed from the scale's platform, and then press the ON/OFF button
to turn the scale on. The display will show "Start", then "0.0" LB. LB (Pounds) is the default
weight measuring unit upon initial set-up/assembly. Press the LB/KG button to select your
desired weight mode (LB or KG).
Note: The battery icon on the display does not indicate battery life. The battery icon is displayed
when the scale is using batteries as the power source.
Note: This scale will always default to the settings and units last used (LB or KG).
Note: If the set up procedure fails, refer to the troubleshooting instructions. If the problem is not
corrected, contact Health o meter Professional Scales Customer Service at 1-800-815-6615.
Note: If "Lo" appears on the display, it indicates that the battery power is low. It does NOT
indicate a problem with the weight measurement.
Warning: If the scale will not be used for some time, remove the batteries to avoid a
safety hazard. Disposal of batteries must be performed in accordance with the prevailing
national, regional or local regulations which apply to
Display assembly
Battery cover
®
Professional recommends using an
you.
14
Locking tab