Tabla de contenido
Publicidad
Bulb Socket Assembly
Assemblage de la lampe
Casquillo portalámparas
+
Felt Packing
Cale en feutre
Empaquetadura
de fieltro
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
Replacing Headlight Bulb
+
Replacing Belt
+
+
Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
+
Install
New Belt
Poser la
nouvelle
courroie
Instalación
de la correa
Remove lower plate.
Remove bulb socket screw, grasp the
bulb socket assembly and pull
upward while moving it back and
forth.
Remove old bulb from the bulb socket
assembly by pushing in while turning
counter-clockwise.
Replace bulb by pushing in while
turning clockwise.
Only use a bulb rated 130 V AC-15
Watts or less.
Reinstall bulb socket assembly into
nozzle housing by pushing it back
down into slot and reinstall bulb
socket screw.
Reinstall lower plate.
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
Remove lower plate.
Lift rear belt cover and remove felt
packing.
Remove agitator by carefully lifting
out.
Remove worn or broken belt.
Clean agitator.
Loop new belt (Panasonic Type UB8
only) around motor shaft and
agitator pulley; see illustration for
correct belt routing.
- 28 -
Publicidad
Tabla de contenido
