Specific Operation Guide; Set Up And Operation - QEP 60083 Manual De Operación

the motor. It is recommended to have an electrician check the voltage at the saw motor to ensure proper voltage
to run the saw efficiently and safely.

SPECIFIC OPERATION GUIDE

1. Ensure that the directional arrow marked on the blade corresponds with the rotational direction of the motor.
2. With the saw disconnected from the power supply, rotate the blade by hand to ensure it is free
from obstruction.
3. Always keep the blade-securing arbor and collars clean.
4. Ensure that the blade-securing bolt is securely tightened.
5. Never try to cut freehand. Always ensure that the tile to be cut is pressed firmly against the rip fence.
6. Ensure that the workpiece that will be cut off has sufficient room to move sideways. Failure to do so may
result in the off-cut binding against the blade.
7. Never cut more than one tile at a time.
8. Never cut pieces too small that are not held securely against the rip fence, and provide enough space for the
hand to be a safe distance from the blade.
9. Ensure that the table and surrounding area are clear with the exception of the tile to be cut.
10. Before cutting a tile piece, let the saw blade run freely for a few seconds. If it makes an unfamiliar sound or
vibrates excessively, switch it off immediately and disconnect it from the power supply.
11. Let the blade reach full speed before commencing the cut.
12. Let the blade come to a complete stop before removing any jammed material from around the
blade area.
13. Never allow the blade to run dry. Failure to keep the water tray at the recommended level will result in
possible over-heating of the diamond blade.

SET UP AND OPERATION

CAUTION! Follow all of the Assembly & Installation Instructions completely before connecting the saw to a
power source or turning the motor on.
Carefully open the container and remove all saw components and packing materials. Ensure that you have
checked each item with the exploded view before discarding the container or packing materials.
The contents of the container are as follows:
• Stainless Steel Locking Rip Guide
• Blade Guard
• Owner's Manual
The following pages illustrate the step-by-step installation of various components and operation of this saw. Read
instructions completely before operating this saw!
ASSEMBLY:
Read the manual carefully before assembly.
1. Place the Rip Guide on the top of the cutting table.
Lock the Rip Guide into place by turning and pressing
down the lever. The Rip Guide can be used on either side
of the cutting blade. (See HK I W TG "5)
2. Make sure that the rip guide is parallel to the blade once
you tighten it down.
BLADE AND BLADE GUARD INSTALLATION:
Use with 7" Continuous Rim Wet Diamond Blades only.
1. Unplug the machine from the power source.
2. Use flat blade screwdriver in slot to hold arbor shaft.
3. Use Hex Wrench (provided) to remove hex nut blade
retainer.
• Angle Cutting Guide
• Saw Frame Assembly
• 7" (180mm) Continuous
Rim Diamond Blade
- 5 -
• Universal Wrench
• Laser Cutting Guide
FIGURE 3
RIP GUIDE
LOCKING LEVER