Operation - QEP 22500Q Instrucciones De Funcionamiento

COULD RESULT IN POSSIBLE SERIOUS
PERSONAL INJURY.
inStaLLinG tHe BLade
(see FIGURE 4)
1. Carefully place the blade onto the shaft and
push it against the inner flange.
2. Be sure the side of the blade with the
directional arrow is facing towards you.
3. Place the outer flange and the blade shaft
nut onto blade.
4. Firmly tighten the blade shaft nut with the
included wrench, but do not over tighten.
CONTINUOUS RIM BLADES WITH THIS SAW.
DO NOT USE SEGMENTED, "TURBO" BLADES,
WOOD SAWING BLADES, BLADES WITH
OPENINGS, OR ANY OTHER CUTTING DEVICES
WITH THIS TILE SAW. USING THESE BLADES
COULD RESULT IN SERIOUS PERSONAL
INJURY AND DAMAGE TO THE SAW.
fIGurE 4
inStaLLinG tHe BLade GUard
(see FIGURE 5)
1. Place the guard support into the socket.
2. Be sure the support is parallel to the blade.
3. Place blade guard onto the support and
tighten wing nut.
fIGurE 5
USE ONLY
inStaLLinG tHe riP GUide
(see FIGURE 6)
1. Place rip guide on the top of the cutting
table and clamp both ends.
NOTE: The rip guide can be placed on either
the left or right side.
fIGurE 6
inStaLLinG tHe anGLe GUide
(see FIGURE 7)
1. The angle guide is designed to fit on top
of the rip guide. Simply place notch in angle
guide onto the top of the rip guide.
NOTE: The angle guide can be placed on either
the left or right side.
fIGurE 7

OPERATION

IMPORTANT: AlWAYS turn off the saw and
remove the plug from the outlet BEFORE
adding or removing accessories and making
adjustments.
THE SAW COULD RESULT IN ACCIDENTAL
STARTING CAUSING POSSIBLE SERIOUS
PERSONAL INJURY.
– 6 –
FAILURE TO UNPLUG