Hilti AG 125-15DB Manual Del Usuario página 29

5 Technical data
For rated voltage, rated current, frequency and/or input power, refer to the rating plate.
If the product is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the product. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the product.
Rated speed
Maximum disc diameter
Thread diameter
Thread length
Weight in accordance with EPTA procedure 01
5.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values
Sound (power) level (L
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Surface grinding with the vibration-absorbing side handle (a
Sanding (a )
h,DS
Uncertainty (K)
6 Before use
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
6.1 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.2 Guard
▶ Observe the instructions for fitting the applicable guard.
2143515
*2143515*
Printed: 20.04.2018 | Doc-Nr: PUB / 5300419 / 000 / 02
)
WA
)
pA
)
pA
AG 125-15DB
11,500 /min
125 mm
M14x1.5
22 mm
2.7 kg
AG 125-15DB
102 dB(A)
91 dB(A)
3 dB(A)
AG 125-15DB
) 4.4 m/s²
h,AG
3.0 m/s²
1.5 m/s²
English 23