Technical Data; Preparations At The Workplace - Hilti DGH 150 Manual Del Usuario

The grinder is designed exclusively for dry abrasive removal of uncoated mineral materials and thin coatings
on concrete and similar mineral materials, with a maximum layer thickness of 3 mm (0.12 in).
Use both hands to hold the product firmly.
3.3 Inadmissible misuse
Do not use accessory tools that are not approved for this product. This includes cut-off wheels, diamond
cut-off wheels and rotary wire brushes.
Do not use the product for wet grinding, do not grind projecting objects such as nails or screws.
Do not use the product with if slats on the dust hood are worn; never use the product without a dust extractor.
Never use the grinding pad at a speed for which it is not approved.
3.4 Items supplied
Grinder, operating instructions, mounting flange, Keyless quick-action clamping screw.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Revolutions per minute (stage 1)
Revolutions per minute (stage 5)
Disc diameter
Disc thickness
5

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Installing an accessory tool
1. Clean the chuck.
2. Slip the mounting flange on to the arbor and turn the mounting flange until it engages.
3. Position the accessory tool on the centering collar of the mounting flange.
4. Screw the quick-action clamping screw into the arbor and tighten the screw.
5.2 Removing the accessory tool
1. Slacken the clamping nut.
2. Remove the accessory tool.
5.3 Adjusting the side handle
1. To release the side handle, open the clamping lever.
2. Adjust the side handle to the desired position.
3. Close the clamping lever.
*2240962*
2240962
4,400 /min
7,000 /min
6 in
4 mm ... 4.5 mm
(0.2 in ... 0.18 in)
English 7