General Information; Safety Advice - BARO Pendiro ID Instrucciones De Montaje

Pendiro ID
ENGLISH
Please read these instructions be-
fore installing and using the lumi-
naire and keep them in a safe place.

GENERAL INFORMATION

The luminaire is an LED luminaire
with a firmly attached lamp. There
are no provisions for replacing the
lamp. The luminaire complies with
currently valid standards and reg-
ulations. It meets the requirements
of protection class III in compli-
ance with DIN EN 60598-1 for
connection to an independent
driver unit in compliance with DIN
EN 61347-2-13 (SELV). Connect-
ing elements (e.g. canopies) may
differ from this and are to be re-
garded separately. Pay attention to
the information on the connecting
elements and the luminaire.
The intended use is the illumina-
tion of items and objects in per-
manent interior rooms. The pro-
tection rating is IP 20. Any other
use does not count as intended use.
We reserve the right to make modi-
fications due to technical advances.
The technical data of the valid data
sheet applies in each case. Damage
caused by disregarding the instruc-
tions is not covered by the warran-
ty. The luminaire is designed for
an ambient temperature of 25°C.
Temperatures above 40°C can
damage the luminaire and greatly
shorten the service life.

SAFETY ADVICE

The luminaire may only be mount-
ed by a qualified electrician. The
local installation regulations must
be adhered to during this proce-
dure. The mains supply must be
disconnected before installation
and maintenance work is carried
out. The luminaire may not be sec-
ondary switched under a load. Pay
particular attention to the polarity
of the LEDs as the LED module
could be damaged.
The luminaire becomes warm
during use. Cooling openings must
remain free of dust and must not be
covered. The connecting elements
are approved for fitting in normal-
ly flammable materials. The safety
clearance to flammable materials
must be adhered to.
The luminaire contains electro-
static sensitive components. Do
not touch the illuminating sur-
face. Mains transients or voltage
peaks can damage the luminaire.
The luminaire must be protected
against damage from grid-related
overvoltage. Damage caused by
overvoltage is excluded from the
terms of the guarantee.
The affixing of stickers or other
parts not authorized by BÄRO is
forbidden. Replacement and addi-
tional parts must be procured from
or approved by BÄRO. Luminaires
that do not work or flicker must
be disconnected from the power
supply. Do not look directly at the
light source. In the event of mal-
functions please inform BÄRO
Service (contact information on
the last page).
SAFETY INFORMATION FOR LU-
MINAIRES WITH CONDUCTOR
RAIL ADAPTER
The canopy for mounting on a
conductor rail is fitted with a EU-
TRAC 3-phase adapter. The con-
ductor rail's EUTRAC data bus
is subject to the safety extra-low
voltage directive. The luminaire
complies with these requirements.
When combining with other DALI
luminaires on a conductor rail (es-
pecially with HIT luminaires) care
must be taken that these luminaires
also comply with the SELV regula-
tions on the DALI bus.
Ø120
Ø96
106
Ø96