ALPHA-TOOLS AHP 2000 Manual De Instrucciones página 7

Anleitung AHP 2000 SPK7
undings or in areas with high
humidity (bathroom, sauna, etc.).
G Check your work area for easily
flammable substances and mate-
rials before using the hot air
pistol.
G Never carry the hot air pistol by
the power supply cord.
G Only use extension cords with a
minimum cross-section area of
1,5 mm 2 .
G Repairs (for example power sup-
ply cord replacement) should be
performed only by a qualified
electrician.
G Do not use chemical paint remo-
vers or solvents at the same time
as the hot air pistol.
G Clean the nozzle when soiled.
G Be sure that the openings for air
entry and exit are always clean
and free of dirt.
G Hazardous or poisonous gasses
can be freed when removing
paint. Be sure to provide adequa-
te ventilation while working indo-
ors.
G Never point the hot air directly at
windows or other glass surfaces.
Start of operation:
Be sure that the power supply vol-
tage matches that printed on the
model name-plate.
Choose the desired temperature
and air quantity with the ON/OFF
switch (2). The hot air pistol rea-
25.10.2005 15:59 Uhr Seite 7
ches the working temperature wit-
hin one minute.
Switch position 1:
1st level - 350 °C / 300 l liters per
minute.
Center position:
The tool is switched off.
Switch position 2:
2nd level - 550 °C / 500 l liters per
minute
Possible uses for the hot air
pistol:
1. Removal of paint and lacquer.
Attention! Hazardous or poiso-
nous gasses may be produced
while removing paint or lac-
quer. Be sure to provide ade-
quate ventilation.
2. Removal of stickers and decorati-
ons.
3. Loosening of rusted or tightly
fastened nuts and metal screws.
4. Thawing of frozen pipes, door
locks, etc. Attention: no not
attempt to thaw plastic or syn-
thetic pipes.
5. Accentuation of natural wood
grains before staining or
lacque-ing.
6. Shrinkage of PVC packaging foils
and insulation tubes.
7. Waxing and de-waxing of skis.
GB
7