Charger Indication Light; Guide For Use; Battery Installation - Clarke CA30 20B Instrucciones De Uso

Ocultar thumbs Ver también para CA30 20B:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A - ENGLISH
CHARGER INDICATOR LIGHTS (FIGURE 3)
(Optional, applicable to models with built-in charger)
1.
When charging starts, the red indication light (45) fl ashes a few times and then steadies to
become a permanent red indication light, entering into the fi rst stage of charging.
2.
After charging for a period of time, the red light (45) will go out. A yellow indication light (46) will
light up permanently: entering the second stage of charging.
3.
After charging for approximately 10 hours, the amber indication light (46) will turn off & the green
light (47) will become permanently lit, indicating that the charge is full, and charging has ended.
NOTE
1)
While charging, if the yellow indication light fl ashes: the battery is incompatible with the
charger, or the battery is not properly connected, or a short circuit has taken place at
the output terminal.
2)
If the red indication light is fl ashing: a short circuit inside the charger. (For details,
please refer to the related sections in the charger instruction.)

GUIDE FOR USE

WARNING !
On certain parts of the machine are pasted some indicative signs:
DANGER !
WARNING !
CAUTION !
CONSULTATION
When reading this manual, the operator must pay particular attention to the symbols on these labels. Under no circumstances shall these labels be
covered. If they are damaged, please replace them immediately.

BATTERY INSTALLATION

WARNING !
If the batteries are incorrectly installed or inaccurately connected, the electric components of the machine may be seriously damaged.
The batteries may only be installed by qualifi ed personnel. According to the battery model number (WET or GEL) being used, set the
functional circuit board and onboard charger (optional).
Please check if the battery is damaged before installing.
Disconnect the battery connector and the on-board charger plug.
Be careful when touching the battery.
This machine requires two (2) 12V batteries. Either wet or GEL / AGM batteries can be used. Please
connect as shown in Figure 4 to the right.
1.
Check the batteries. Ensure the connector (9) is connect to the battery pack.
2.
Press the on / off switch (41) into the "on" position. If the green light is on, that indicates the
batteries are ready for use. If the amber or red light is on, that indicates the batteries need
charging. (Please refer to the section on maintenance for related procedures)
A - 8
INSTRUCTIONS FOR USE
CA30 20B - 56091130
47
46
45
FIGURE 3
12V
12V
FIGURE 4
7/2014

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Clarke510b

Tabla de contenido