Design Features - Rockford Fosgate PUNCH PBR300X4 Instalación Y Funcionamiento

D F
ESIGN EATURES
BRT(Boosted Rail Technology) LED – This LED illuminates when the unit is in boost mode.
1.
Power/Protect LED – This LED illuminates Blue when the unit is turned on and Red if a short
2.
circuit/low impedance is detected at the speaker connections or the amplifier's internal components
become too hot engaging the protection. The amplifier will shut down to cool if this occurs.
Extruded Aluminum Heatsink – The extruded aluminum heatsink of the Punch amplifier dissipates
3.
heat generated by the amplifier's circuitry.
Speaker Harness Connection (Output) – The Molex connection port for the mating + and -
4.
speaker harness.
Crossover Switch – Selectable switch for 80Hz High-Pass (HP),All Pass (AP), or Low-Pass (LP)
5.
operation.
Gain Control – The input gain control is preset to match the output of most source units. It can be
6.
adjusted to match output levels from a variety of source units.
2/4 Channel Switch – Setting this switch to the 2CH. position, switches the inputs to a 2-channel
7.
mode, allowing connection to only the front inputs with a 4-channel output.
RCA/Speaker Harness Connection (Input) – The Molex connection port for the mating
8.
RCA/Speaker harness.
Variable High Level Adjustment – With the High Level Switch engaged a variable 4V to 6V
9.
DC(Direct Current) offset voltage input turn on can be set.
10. Power Terminals – The Molex connection port for the mating Remote/Ground/Power plug.
4