Setup And Operating Options; General Setup Diagram; Meanings Of The Various Parameters; Memorising The Remote Control For Partial Opening Cycle - SOMFY Dexxo Optimo RTS Manual De Instalación

SETUP AND OPERATING OPTIONS

General setup diagram

Meanings of the various parameters

Programming example: adjusting the long slowdown zone "P1=3" (Fig. 24)
Code Description
Obstacle detection sensitivity
P0
Closure approach speed
P1

Memorising the remote control for partial opening cycle

Memorising the remote control for controlling lighting

Memorising a Telis or similar type remote control

SPECIAL OPERATION

Refer to the User's Manual.

CLEARING REMOTE CONTROLS AND ALL SETTINGS

Clearing remote controls

Press the "PROG" button until the light blinks (7 s).
This clears all of the remote controls memorised.

Resetting all settings

Press the "SET" button until the light goes out (7 s).
This clears all previously stored settings and returns them to their default values.

LOCKING PROGRAMMING

Used to lock the programming settings (end limit setting, self-learning, setup).
Simultaneously press the "SET", "+" and "-" buttons:
- start by pressing "SET".
- pressing "+" and "-" must take place within two seconds.
Pressing the "SET" button then no longer has any effect.
The remote control memorising functions ("PROG" button) and forced mode operation ("+", "-" buttons) remain possible.
To access programming mode once again, repeat the same procedure.

REFITTING COVERS

Position the aerial and fit the covers.
To ensure proper remote control range, the aerial must be fitted in one of the two positions shown in Figure 31.
Fig. 23
Values
1 : low sensitivity
2 : low sensitivity
3 : standard
4 : high sensitivity
1 : no slowdown
2 : short soft stop
3 : long soft stop
Fig. 28
Fig. 29
(Fig. 30)
(Fig. 31)
Comments
If this setting is changed, it is essential to run the force measurement
sequence at the end of the installation procedure
P1=1: no slowdown before closure.
P1=2: speed is reduced during the last 20 centimetres.
P1=3: speed is reduced during the last 50 centimetres.
If this setting is changed, it is essential to run the force measurement
sequence at the end of the installation procedure.
Fig. 25
Fig. 26
Fig. 27
7