Altering An Option Or Arunning Programme; Interrupting Aprogramme; Cancelling A Programme - AEG LAVAMAT 82470 BI Manual De Instrucciones

SETTING THE DELAY START
(BUTTON 9)
Before you start the programme, if you
wish to delay the start, press the button 9
repeatedly, to set the desired delay.
The symbol appears on the display.
The wash programme can be delayed
from 30 min. - 60 min. - 90 min., 2 hours
and then by 1 hour up to a maximum of
20 hours.
The set delay time value appears on the
display for about 3 seconds, then the du-
ration of the programme appears again.
Set this option after you have set the pro-
gramme and before you press the button
8.
You can modify or cancel the delay time
at any moment, before you press the but-
ton 8.
The door will be locked throughout the
delay time. If you wish to add laundry in
the appliance during the delay time, press
the button 8 to set the machine to pause.
When the symbol
door can be opened. Add the laundry,
close the door and press the button 8
again.
Setting the delayed start.
• Set the programme and the required
options.
• Set the delay start.
• Press button 8: the appliance starts its
hourly countdown. The programme
starts after the selected delay has ex-
pired.
Cancelling the delayed start
• Press the button 8 to set the appliance
to PAUSE;
• Press button 9 until the symbol
displayed;
• Press the button 8 again to start the
programme.
The set delay can be changed on-
ly after you have set the washing
programme again.
The Delay Start cannot be set with Drain
programme.
ALTERING AN OPTION OR A
RUNNING PROGRAMME
It is possible to change some options be-
fore the programme carries it out. Before
disappears , the
' is
you make any change, you must press the
button 8 to pause the appliance.
Changing a running programme is possi-
ble only by resetting it.
Turn the programme dial to
to the new programme position.
Press the 8 button again to start the new
programme. The washing water in the tub
will not emptied out.
INTERRUPTING A
PROGRAMME
Press the button 8 to interrupt a pro-
gramme which is running, the corre-
sponding light starts blinking. Press the
button again to restart the programme.

CANCELLING A PROGRAMME

Turn the selector dial to
programme which is running. Now you
can select a new programme.
OPENING THE DOOR AFTER
THE PROGRAMME HAS
STARTED
First press the button 8 to set the appli-
ance to pause by .
• If the symbol
door can be opened;
• If the symbol
means that the appliance is already
heating or that the water level is too
high. In this case the door cannot be
opened;
• If you cannot open the door but you
need to open it, you have to switch the
appliance off by turning the selector di-
al to /Off. After a few minutes the
door can be opened (pay attention to
the water level and temperature!);
After closing the door, it is necessary to
set the programme again and to press the
button 8.
AT THE END OF THE
PROGRAMME
The appliance stops automatically, the
light of button 8 goes off. A blinking
appears on the display and the acoustic
ENGLISH
17
and then
to cancel a
disappears, the
doesn't go off, it