Using The Appliance - Washing & Drying; Non-Stop Programme - AEG L 75480 WD Manual De Instrucciones

20 www.aeg.com
• The display shows a time value, calcu-
lated on a default load size. If the
amount of your laundry is more or less
than the default size, the appliance
adjusts automatically the time value
during the cycle.
• Press the button
gramme.
You cannot set all levels for all
type of laundry.
With the timed drying:
• Press the button
to set the drying time value (see the
«Programme for timed drying» table).
The display shows a minimum time
value.
• Each time you press this button the
time value increases by 5 minutes.
• After some seconds the time value on
the display changes: the appliance cal-
culates also the duration of the anti-
crease and the cooling phases.
11. USING THE APPLIANCE - WASHING & DRYING

11.1 NON-STOP programme -

Washing & Automatic drying
CAUTION!
Do not put a plastic device/ball
for the detergent into the
drum.
• Press button
ance.
• Load the laundry.
Cupboard dry symbol
Iron dry symbol
4 to start the pro-
The door locked symbol
comes on.
The drying symbol starts to
flash.
again and again
7
Set time value
Final time value
1 to activate the appli-
• Press button
4 to start the pro-
gramme. The display shows the new
time value every minute.
The drying symbol starts
to flash.
The door locked symbol
comes on.
If you set the time value of only
10 minutes, the appliance per-
forms only a cooling phase.
At the end of the programme
• The appliance stops automatically.
• The acoustic signals operate.
•
In the display comes on.
• The indicator of the Start/Pause but-
ton 4 goes off.
The last minutes of the drying cy-
cle the appliance performs the
anti-crease and the cooling pha-
ses.
• Press button
1 to deactivate the ap-
pliance. After some minutes from the
end of the programme, the energy
saving function automatically deacti-
vates the appliance.
•
When the door locked symbol
goes off, you can open the door.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
• Measure out the detergent and fabric
conditioner.
• Turn the programme dial to the wash-
ing programme. The display shows the
wash symbols.