Heath Zenith 7753 Manual Del Usuario página 3

Inside Push Button
CHIME
VOLUME
TUNE:
HOLD 1 SEC
SYNC:
HOLD 3 SEC
RESET:
HOLD 10 SEC
Inside Chime
Tune Setting Table
Tune
Ding
Ding-Dong or
Westminster
1. PROBLEM: Chime does not sound.
A. POSSIBLE CAUSE: Batteries not installed correctly.
A. CORRECTIVE ACTION: Make sure batteries are installed according to
the diagram inside the push button and chime.
B. POSSIBLE CAUSE: Batteries are dead.
B. CORRECTIVE ACTION: Check charge of push button and chime bat-
teries and replace if necessary.
C. POSSIBLE CAUSE: Push button and chime are not synced.
C. CORRECTIVE ACTION: Sync the push button and chime.
• Press and hold the button on the chime until the chime sounds a
"Beep-Beep".
• Press the push button within 30 seconds. The chime will sound a
"Beep-Beep" tone to indicate the push button is synced.
• Press the push button to ensure operation.
Helpful Videos – www.hzsupport.com
Tune Settings
The chime has different selectable tunes: Ding
(one note tune), Ding-Dong (two note tune), or
Westminster (eight note tune). The factory set-
ting is for the Westminster tune. This tune can
be changed by following the instructions in the
Tune Setting Table.
Note: All chime models are designed to work with
up to 5 push buttons (sold separately). All chimes
are designed to play only two different tunes no
matter how many push buttons are used.
Push Button
Jumper - ON
Jumper - OFF
Troubleshooting
Press button on chime. Listen for single
"Beep" tone. Release button. Listen for se-
lected tune. Repeat to select different tune.
Helpful Answers – 1-800-858-8501
Chime
———
3