Setting The Sleep Timer; Sound Adjustment - Aiwa LCX-107 Manual De Instrucciones

GENERAL
En

Sound Adjustment

VOLUME (VOL)
Press VOLUME i or k. The volume level is displayed as a
number from 0 to MAX (25).
•The volume level is automatically set to 14 if the power is
turned off when the volume level is set to 15 or more. (except
when turning the power back on within 4 seconds)
To display the volume level when a function other
than TAPE function is selected
Press VOLUME i or k. The volume level is displayed for
4 seconds.
DISPLAY on the remote control is also available.
To listen with the headphones
Connect headphones with a stereo mini plug to the PHONES
jack.
8
ENGLISH
LCX-107 (U) Eng 8
3-MODE EQ (equalizer)
Press * 3-MODE EQ repeatedly.
The equalizer mode changes to RO (rock), PO (pop), JA (jazz)
or OF (off) cyclically.
RO (rock) - Emphasizes the high and low range of music.
PO (pop) - Emphasizes voice and midrange of music.
JA (jazz) - Emphasizes the low range of music.
* or EQ on the remote control
•Volume or tone adjustment does not affect recording.
11/21/00, 10:26 AM

Setting the Sleep Timer

The unit can be turned off automatically at a specified time.
1 Keep REPEAT/SLEEP/FM MODE/OSC pressed
until "30" flashes in the display.
2 Within 4 seconds, press f or g to specify
the time until the power is turned off.
Each time it is pressed, the time changes between 10 and
90 minutes in 10-minute steps.
Specified time
While the sleep timer works,
the dot keeps flashing.
To check the time remaining until the power is
turned off
Repeat step 1 shown above. The remaining time is displayed
for 4 seconds.
To cancel the sleep timer
Display the remaining time and press f or g repeatedly
until OFF is displayed.
Note
If the unit is turned off during tape playback, c on the deck
will not be released. Press Z to release c.