Turning The Unit On/Off; Performing Initial Setup; Receiving Gps Signals; Basic Operations - Sony NV-U Serie Guia De Inicio Rapido

Turning the unit on/off

To turn the unit on/off
Press ?/1 (1).
Note
If you do not use the unit for a long term, the built-in
battery may be depleted, and the unit will not turn on.
In such a case, connect the car battery adapter and
charge the unit.
After you charge the unit, it may take time to receive
GPS signals when turning on the unit.

Performing initial setup

Follow the on-screen instructions to perform the
setup.
The setting can then be further configured in the
setting menu at any time (page 10).

Receiving GPS signals

After the initial installation, park your car in a
safe, open place (no high buildings, etc.) for up
to 20 minutes to allow for GPS signals to
calculate the current car position properly before
using the navigation system.
The GPS signal reception condition icon is
displayed on the screen. The
up in red when the signal cannot be received.
6

Basic Operations

Common procedures to operate the system are
explained.
General operations can be performed on the
touch screen. Touch the displayed icons with
your finger gently.
Note
Do not press the display with excessive force, or use
any sharp article, such as a pen, etc., to tap on the
display.

Menu operation

The top menu appears when turning on the unit
by pressing ?/1 (except during route guidance, in
which case the map appears).
To show the top menu from the map display,
touch the map.
indicator lights
To return to the top menu from any menu display,
touch VOICE/POS., then touch the map.
During menu operation:
To return to the previous display, touch
To cancel the menu selection, touch VOICE/
POS. (the current car position display appears).
.
or