General Safety Practices; Basic Operation Procedures - Skymsen DB-6 Manual De Instrucciones

4. General Safety Practices

If any item from the GENERAL SAFETY NOTIONS section is not applicable to your
product, please disregard it.
The following safety instructions are addressed to both the operator of the machine as well
as the person in charge of maintenance.
The machine has to be delivered only in perfect conditions of use by the
user. The user shall operate the machine only after being well acquainted with the safety procedures,
and after reading carefully the entire manual.

4.1 Basic Operation Procedures

4.1.1 Dangers
Some areas of the electric device have parts and terminals that are connected to high
voltage. These parts when touched may cause severe electrical shocks or even be lethal.
Never touch manual commands such as switches, buttons, keys and knobs with wet hands,
wet clothes and/or wet shoes. By not following these instructions, operator could be exposed to
severe electrical shocks or even to a fatal situation
4.1.2 Warnings
The operator has to be well familiar with the position of ON/OFF Switch to make sure the
Switch is easy to be used when necessary.
Before any kind of maintenance, physically remove the plug from its socket.
Provide space for a comfortable operation thus avoiding accidents.
Water or oil spilled on the floor will turn it slippery and dangerous. Make sure the floor is clean
and dry.
Never use a manual command (switch, buttons, lever) unadvisedly.
If any work is to be made by two or more persons, coordination signs will have to be given for
each operation step. Every step of the operation shall be taken only if a sign has been made and
responded.
4.1.3 Advices
In case of power shortage, immediately turn the machine OFF.
Use recommended or equivalent lubricants, oils or greases.
Avoid mechanical shocks as they may cause failures or malfunction.
Avoid penetration of water, dirt or dust into mechanical or electrical components of the
machine.
DO NOT MODIFY original characteristics of the machine.
DO NOT REMOVE, TEAR OFF OR MACULATE any safety or identification labels of the
machine. If any label has been removed or is no longer legible, contact your nearest dealer for
replacement.
IMPORTANT
Distributor to the
08