Husqvarna 530iPX Manual Del Usuario página 10

saw chain that is damaged or incorrectly sharpened
increases the risk of accidents.
• Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth gauge
setting. Too large depth gauge setting increases the
risk of kickback.
• Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the guide
bar, the saw chain can derail. An incorrect saw chain
tension increases wear on the guide bar, saw chain
and chain drive sprocket. Refer to
chain on page 21 .
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
Battery safety
WARNING: Read the warning instructions
that follow before you use the product.
• Only use the BLi batteries that we recommend for
your product. The batteries are software encrypted.
• Use the BLi batteries that are rechargable as a
power supply for the related Husqvarna products
10
•
•
•
•
•
•
•
•
•
To tension the
•
•
•
Battery charger safety
•
•
•
•
•
•
•
•
only. To prevent injury, do not use the battery as a
power supply for other devices.
Risk of electrical shock. Do not connect the battery
terminals to keys, screws or other metal. This can
cause a short circuit of the battery.
Do not use batteries that are non-rechargable.
Do not put objects into the air slots of the battery.
Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
Keep the battery away from microwaves and high
pressure.
Do not try to disassemble or break the battery.
Do not let battery acid touch your skin. Battery acid
causes injuries to the skin, corrosion and burns. If
you get battery acid in your eyes, do not rub but
flush with water for minimum 15 minutes. If battery
acid has touched your skin, you must clean the skin
with a large quantity of water and soap. Get medical
aid.
Use the battery in temperatures between -10 °C (14
°F) and 40 °C (104 °F).
Do not clean the battery or the battery charger with
To clean the product, the battery and
water. Refer to
the battery charger on page 22 .
Do not use a defective or damaged battery.
Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
Keep the battery away from children.
WARNING: Read the warning instructions
that follow before you use the product.
Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
Use an approved grounded mains socket that is not
damaged.
Do not use other battery chargers than the one
supplied for your product. Only use Husqvarna QC
chargers when you charge Husqvarna replacement
batteries BLi.
Do not try to disassemble the battery charger.
Do not use a defective or damaged battery charger.
Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the cable
is not caught between doors, fences or similar.
Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
774 - 003 - 28.05.2019